What are the common debugging methods for dispensing robots?

At present, the application range of dispensing robots is very wide, and its applicable industries include the electronics industry, lighting industry, automotive industry, industrial electrical, construction engineering and so on. Today, Ruichi Robot introduces you to the common debugging methods of dispensing robots.



1Pressure setting of dispenser


The amount of glue output is provided by the automatic dispenser controller to the hose and the needle. The pressure determines the amount of glue and the speed of dispensing. The strong pressure will easily cause the glue to be sprayed and the amount of glue is too much, affecting the product. Aesthetic appearance; weak pressure will result in uneven dispensing and leaks, which will affect product quality problems. In actual production, the pressure should be set according to the viscosity of the glue, the environment of the production workshop, and the temperature. Too low a temperature will increase the viscosity of the glue and reduce the fluidity. In this case, you need to increase the pressure value, and vice versa.


2Needle size of dispenser


In actual production, the inner diameter of the needle should be the same as the radius of the glue point. In the dispensing work, the needle can be selected according to the size of the product. For different sizes of products, the appropriate needle should be selected, so that the automatic dispenser can be used for dispensing. For glue operation, there is no need for glue points, and the height from the needle to the circuit board and the inner diameter of the needle are important parameters.


3Dispensing time setting


The amount of glue should be half of the product spacing, so that there can be enough glue to paste the components to avoid excessive glue leakage. The amount of glue dispensed by the automatic dispenser can be controlled by adjusting the dispensing time. In actual production work, the dispensing settings can be set according to the environmental conditions (workshop temperature, glue viscosity, dispensing speed, etc.) time.


Product recommendation of Ruichi dispensing robot: R501DJ high-precision double-station dispensing robot




1Adopt industrial control computer control system;

2Can add CCD automatic correction function;

3Single machine can be operated, simple and convenient, high speed and accurate;

4Computer storage mode, convenient for data management and file transfer between machines;

5It can be equipped with a two-component pumping glue system to form a two-liquid dispensing machine;

6Support EMS data upload;

7It has the functions of drawing points, lines, surfaces, arcs, circles, irregular curves, continuous interpolation and four-axis linkage.


The above is about the common debugging methods of dispensing robots. For more products, please consult Ruichi Robot.